Step 1: Trim Your Design ✂️

Use scissors to carefully cut around the edges of your tattoo design. This step is optional, but trimming close to the artwork gives your tattoo a clean and natural look.

Step 2: Remove the Clear Film 🔍

Peel off the protective plastic sheet from the front of your tattoo.

Step 3: Place the Tattoo Face-Down 🤚

Position the tattoo where you’d like it and place the design face-down against your skin.

Step 4: Add Water 💦

Press a wet sponge, paper towel, or cloth firmly onto the back of the tattoo. Hold in place for about 30 seconds, making sure the paper is soaked through.

Step 5: Peel & Reveal ✨

Gently peel away the backing paper to reveal your tattoo. Let it air dry for up to 1 hour for the best finish. The shine/glare will fade as it fully sets, leaving you with a realistic look.